PROLEC James Fisher PME400 - Height Limit Setting - Known Height

562400-000, Issue 1.3 January 2022
Page 18 of 61
7.1.2. Height Limit Setting - Known Height
A known limit can be entered into the display. This is the
vertical height from the ground or base of the machine.
Step One: Press the ’Enter a limit value’ button
Step Two: Use the UP and DOWN Arrow buttons to increase and decrease the highlighted number. Use
the LEFT and RIGHT Arrow buttons to move the highlighter to the left and to the right. Set a limit and
press Green TICK to accept:
Once a limit is set, the internal alarm will sound and the RED LED will
light if the equipment exceeds the current limit. Always check that the
current limit activates at the set point. The restriction cannot be
deactivated if in the alarm state. Observe the operational limitations
given in section
4
.
Increases highlighted
digit
Decreases highlighted
digit
Accept
displayed
value
Cancel without
change
Moves highlighter to
right
Moves highlighter to
left / Hold to delete
digit
Enter a limit value
Exit to previous