Using ProSoft Configuration Builder PLX3x Series ♦ Multi-Protocol Gateways
User Manual
Page 30 of 215 ProSoft Technology, Inc.
January 25, 2018
If the Test Connection procedure fails, you will see an error message. To correct
the error, follow these steps.
1 Click OK to dismiss the error message.
2 In the Upload dialog box, click BROWSE DEVICE(S) to open ProSoft Discovery
Service.
3 Right-click the module and then choose SELECT FOR PCB.
4 Close ProSoft Discovery Service.
5 Click DOWNLOAD to transfer the configuration to the module.
To Next Page
Loading...
Need help?
General
