Pulsar SLUDGE FINDER 2 User Manual

Page 55
Hot Keys
There are five hot keys on the keypad that can be used to quickly access common
parameters for viewing only, while in Run Mode. Pressing the hot key once will
initiate or toggle the function assigned to that key, then the Sludge Finder 2 reverts
to the Run Mode display, if applicable. In program mode, they have different
functions. Information displayed by the function keys in the “Main” screen will
timeout and disappear after 20s. The functions are shown below:
Hot
Key
Run Mode
Program Mode
Toggle status, echo strength,
wiper status and temperature
display in the “Main” screen.
Toggle the Gate display in the
“Echo” screen.
Clear the current value.
Toggle distance, level and space
display in “Main” screen.
Toggle the DATEM trace in
“Echo” screen.
Not used with Sludge
Finder 2.
Toggle mA output display in the
“Main” screen.
Reset parameter to default
setting.
Not used with Sludge Finder 2.
Not used with Sludge
Finder 2.
Initiates a wiper sweep on the
sludge transducer face (VT
transducers on single point main
display only).
Not used with Sludge
Finder 2.
Not used with Sludge Finder 2.
Toggle negative values.
Displays the information screen,
timeout 20 seconds.
Enter decimal point.

Pulsar SLUDGE FINDER 2 Specifications

General

Brand	Pulsar
Model	SLUDGE FINDER 2
Category	Measuring Instruments
Language	English