Page 53
Program Mode
This mode is used to set up the Sludge Finder 2 or change information already
set. You must use the built-in keypad to access program mode. Alternatively the
unit can be set up with a PC via the RS 232 Serial Interface.
Entering a value for each of the parameters that are relevant to your application
provides all of the programming information.
How to Access Program Mode
With Sludge Finder 2, to enter program mode, you simply enter the passcode,
via the keypad, followed by the ENTER key. The default passcode is 1997, so you
would press the following:
Note
There is a time-out period of 15 minutes when in program mode, after
which time run mode will be resumed. The timer is reset every time a key
is pressed.
To Next Page
Loading...
Need help?
General
