Page 101
Miscellaneous
P210, 220, 230, 240, 250, 260 = 3 (Miscellaneous)
When a relay is set to be a miscellaneous relay, the second parameter determines
its function.
P211, P221, P231, P241, P251, P261 - Relay Function,
This function allows the relay to work in relation to a clock or a specific event and
will be set to activate in relation to Real Time.
Relay will energise ON at a specified time each
day as set in Relay Setpoint 1 (P213, 223, 233,
243, 253, 263). And turns OFF, de-energises,
after the specified On Time period as set in Relay
Setpoint 2 (P214, 224, 234, 244, 254, 264)
Important Information
When using a Relay to control a device at a specified time of day ensure that
the Time P932 is set correctly. And if required, enable Daylight Saving for
the appropriate time difference P970 – P979.
The third parameter has no function when miscellaneous relay is chosen and
will not be displayed.
The fourth parameter, and fifth parameter, are set to determine the switch
points, “ON” and “OFF” for the relay. See miscellaneous function table (P211,
221, 231, 241, 251, 261) for further information.
P211, 221, 231, 241, 251, 261 = 1 (Clock)
P213, P223, P233, P243, P253, P263 - Relay Setpoint 1
Relay Setpoints are entered in Hours & Minutes (HH:MM) to set Time at which
relay will energise. Default = 00:00 (HH:MM)
P214, P224, P234, P244, P254, P264 - Relay Setpoint 2
Relay Setpoints are entered in Minutes to set Time Period that the relay will remain
ON. Default = 0.00 mins.