EasyManuals Logo

Pulsar SLUDGE FINDER 2 User Manual

Pulsar SLUDGE FINDER 2
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
Page 20
Preparation for Operation
Before switching on, check the following:
Sludge Finder 2 is mounted correctly and is in a ‘safe’ area.
The power supply is correctly installed.
The relays are wired correctly.
Maintenance
There are no user serviceable parts inside Sludge Finder 2, except the mains fuse.
If you experience any problems with the unit, then please contact Pulsar Process
Measurement for advice.
To clean the equipment, wipe with a damp cloth. Do not use any solvents on the
enclosure.
Transducer Maintenance.
Procedure for the Removal of Transducers
From time to time it may be necessary to remove the transducer for cleaning or
maintenance purposes, the following procedure is to ensure that this is done
carefully with regard for the health and safety of the operator involved, and without
damage to the transducer.
The transducer mounting bracket (option 1) is designed such that the transducer
can be removed without any parts being available to fall into the application.
Before attempting to remove the transducer for cleaning or maintenance, the power
to the unit should be disconnected.
The correct PPE should be worn to ensure you do not come into direct contact with
the wetted parts of the Sludge Finder 2 system, if in doubt contact your site Health
and Safety Officer.
To remove the transducer, loosen the retaining bolts on the end of the mounting
brackets as shown in fig.1 and lift the transducer conduit assembly onto the
walkway. The conduit is attached to the mounting assembly plate by means of a
security chain so that it cannot be dropped and lost into the application.

Table of Contents

Other manuals for Pulsar SLUDGE FINDER 2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pulsar SLUDGE FINDER 2 and is the answer not in the manual?

Pulsar SLUDGE FINDER 2 Specifications

General IconGeneral
BrandPulsar
ModelSLUDGE FINDER 2
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals