Page 50
Run Mode
This mode is used once the Sludge Finder 2 has been set up in program mode. It
is also the default mode that the unit reverts to when it resumes operation after a
power failure.
When Sludge Finder 2 is switched on for the first time, it will display, in metres,
a level measurement relating to the default tank dimensions. All relays by default
are switched off.
After programming is complete, any relays that are set will operate when the level
reaches the relevant setpoint, and the LED’s will change colour (unless specifically
switched off).
Main
This group of screens provides information on Point 1, Point 2 or an overview of
both Points. Use the up and down arrows to scroll between points 1, 2 or both.
Below is an example of point 1, this is the screen that will be displayed when the
Sludge Finder 2 is switched on for the first time.
Error messages, such as “Wiper Fault”, “Status = LOE” or “Status = Failed” will
be displayed on this screen, relating to the point of measure currently being
viewed, when a fault condition occurs.
To Next Page
