7. Put the moistener back into place.
Scale Not Working
• Check that scale cable is connected.
• Make sure machine is on a stable surface.
• Re-Zero the scale by performing the following steps:
1. Remove all items from the weighing platform.
2. Press the “C” button for 3 seconds.
3. Press to acknowledge that nothing is on the scale.
4. Press when done.
5. The machine will display zero value for weight
6. Place your item on the scale to process your mail.
• If problem persists, contact your local service representative.
The Weighing Device does not Weigh Properly
If the Base does not display a correct weight, complete the following actions to correct
the problem.
You have to check the weighing device as follows.
ActionsPossible causes
Use a solid and steady table:
• Away from any door
• Away from any fan.
There are vibrations or air drafts
in the weighing area.
Clear the weighing zone and re-zero the Weighing
Platform (see Weighing Settings on page 184).
Something is touching or laying
on the Weighing Platform.
See the weighing platform zeroing procedures in
Weighing Settings on page 184.
The Weighing Platform zero is not
correct.
1. Press [OK] to clear the error message.
2. Press the [Rate] key and select a rate class
that can accommodate the weight of the
package. (Example: select Priority if the rate
you had been using was First Class).
3. Press lightly on the Weigh Platform to
establish the weight and postage with the new
rate.
You have placed a package on the
platform that is too heavy for the
rate selected.
250
| Page 250 | Apr-28-2023 03:14 |
13
Troubleshooting
To Next Page
Loading...
Need help?
General
