31
15. SETTING ACCESSIBILITY OF WORK MODES
In P8 parameters group users can declare work modes that are accessible
directly under the Mode key during operation.
Fig. 16. Work modes - setting
Every operation mode can be enabled/disabled separately.
16. OTHER PARAMETERS.
Users can set parameters influence the operation of the balance in group of the
parameters P9 Others e.g. beep signals etc
01 Address
(not active)
02 ID Setting
it includes 6 digits 6 codes which can be used during printouts for product
specification, operator, batch etc.
03 ID autoprint
for the option YES all digital codes are printed, for option NO the codes
are not printed.
To Next Page
Loading...
