77
26.3. Transmission characteristics
Scales with MCB X.XX program use two different ways of transmission:
• Continuous transmission or automatic printout (RS 232 and RS 485)
• of request-response messages (request messages via RS 232 and
response messages via RS 232 or RS 485)
26.4. Continuous transmission/automatic printout
26.4.1. Types of printouts
There are 3 t
y
pes of automatic printouts in the scale provided it is not a retail
scale and the DRH parameter in factory parameters is not enabled.
Notice:
If the parameter DRH is set to 1 this parameter is locked for edition, but it is
possible to start continuous transmission by using a RS232 command.
Settings/ RS-232/ Aut. printout
No Name Description
0 No Request-response
1 Contin. Continuous transmission
2 With int.
Continuous transmission with the time pause between the
subsequent printouts. The pause is set in the next
parameter in the menu.
3
When
stab.
Printouts are automatically generated after each stable
measurement over min. mass (next parameter).
The next printout can be generated when the result
achieves the value below the Min. mass and again over it.
To Next Page
Loading...
