43
17.2. Settings of operating for counting pieces
17.2.1. Configuration
In this menu way of balance operating in counting pieces mode is defined.
After pressing arrow to the right list of parameters will open. Choice is done by
arrows up and down however enter to edition arrow to the right. Choice of
parameter value arrow up or down.
Fig.25. Screen operating settings
Following parameters are available for edition:
Auto Opt. Automatic accuracy correction
Data+ Constant defined date (e.g. date of assortment introduction)
Aut. printout Automatic printout activating
Min. Pcs
Connected with automatic printout.
It is value of pieces below which indication must go by weighing next
portion of assortment (removing portion from the pan and placing
next portion). Automatic printout is possible if pieces quantity is
bigger than “Min. Pcs” value.
Result control
Activating terminal operating mode with result control (label is printed
when counted assortment fulfils conditions Min pcs Max pcs)
C label Way of initiating printout of cumulative label (key, pieces, counter)
CC label Way of initiating printout of cumulative label from cumulative labels
Login Inactive
II line
Choice of information displayed in II line of display to choose:
OPERATOR N1 – name of operator and counter of N1 labels are
displayed
N1 SUM1 N2 – value of N1 labels counter, total quantity of pieces
SUM1 and N2 counter (cumulative labels) are displayed
V1 N1 – text defined under V1 and N1 labels counter are displayed
V2 N1 – similarly as above
PRICE VALUE – price of an article and value according to mass
indication in real time
AI defining Defining of application identifiers AI1 to AI6
DATABASE Transfer Database exchange via RS 232 using „DB editor” software
To Next Page
Loading...
