RADWAG WLT L Series - Survey of Automatic Printouts

79
Standard length is 18 characters, but if the parameter digit marking has been
enabled, the length increases to 20 characters, because additional brackets
are printed e.g.:
383 kg
38[3] kg
3[83] kg
It can be set in :
Settings/Factory/digit marking
Frame format:
[space] [sign] [mass] [space] [unit] [CR LF]
sign – [space] for positive values or [-] for negative values
mass – 9 characters justified to the right
unit – 3 characters justified to the left
This type of printouts can be enabled in parameters:
Settings/RS-232/Aut. print/when stab.
Setting the Min. mass is possible in:
Settings/RS-232/Min. mass
Notice:
The result is printed in current unit.
26.4.5. Survey of automatic printouts
No Name Frame
Quantity of
characters
0 No
[Command] [space] [stability] [space] [sign]
[mass] [space] [unit] [CR LF]
20-22
1
Continu
ous
[SI] [space] [stability] [space] [sign] [masa]
[space] [unit] [CR LF]
21
2
Wit
interv.
[SI] [space] [stability] [space] [sign] [masa]
[space] [unit] [CR LF]
21
3
When
stab.
[space] [sign] [space] [mass] [space] [unit]
[CR LF]
18