44
Fig. 26. View of screen in counting pieces mode
II line
Change of any parameter is done by pressing arrow to the right and next
using keyboard enter appropriate values.
Changes are confirmed with ENTER key or cancelled with ESC key.
Exit from edition with ESC key. Exit on menu level higher again ESC key
17.2.2. Printer settings
In this menu printer operating is configured. Way of moving in menu is
analogical to previous ones.
Fig.27. Screen of printer settings
Quantity of labels Quantity of printed labels after single PRINT signal
Inch system By setting on NO metric system is on
Tear off dist. Distance in pixels left free space on printout (0 – 999)
Label cut
Function activating label cutting device (when printer is
equipped with such device)
Gap sensor Switch on or off the gap sensor
To Next Page
Loading...
