8
3.3. Balance levelling
To do the measurements correctly level the scale. Take the pan off carefully
(without rapid pulls and hits) and turn the legs in order to level the balance, air
bubble should be place in the centre of level condition indicator.
Fig. 2. Balance levelling
1- correct levelling
2- incorrect levelling
4. UNDER-FLOOR WEIGHING
For scales with 165 x 165mm platforms can weigh underslinged loads (hanged
under the balance floor). In case of using this function:
− remove the hole plug made of plastic (placed in the balance floor),
− a suspension can be seen in the hole. It is standard equipment,
− Mount an appropriate hook for hanging loads (hook is non-standard
equipment).
1. The suspense cannot be rotated, revolved or tampered in any way,
because of direct connection with the weighing mechanism of the
balance.
2. All the additional elements like pan, string etc. should be tarred (TARE).
3. Balances with 300 x 300mm or 410 x 410mm platforms do not have the
under-floor weighing mechanism.
To Next Page
Loading...
Need help?
General
