85
27. ERROR MESSAGES
Message
Error
No
Description
"checksum error"
1.1
Errors during date transmission
"A/D Error"
1.2
A/D Converter error
" Exceed range "
2.2
Exceeded max measure range of the balance
"A/D Null"
2.3
No value from A/D converter
"A/D Full"
2.4
Exceeded max value converter intervals
"Tara/Zero above the
range"
2.5
Exceeded tare or zero range
"Tara above the
range "
2.6
Exceeded tare range for the balances
"Zero above the
range"
2.7
Exceeded zero range for the balances
"Result > 4% Max"
2.8
To high start mass (balance started with load on the
pan)
"Result > 1% Max"
2.9
Difference between determined calibration mass
and calibration mass recorded in the balance
memory higher than (difference >1%)
"Piece < 1 Div"
2.10
Singular mass value in counting pieces function
less than actual scale interval
Piece < 10 Div"
2.11
Mass on the pan during determining mass of
singular piece in the function of counting pieces
less than 10 actual scale intervals
"beyond the range"
3.1
The parameter value above the range
"Faulty value"
3.2
Inadmissible value of the parameter
"Blocked - DRH"
3.3
The parameter cannot be changed (Function DRH
active in the factory menu)
"Overwrite error"
4.1
" Party error"
4.2
" Frame error"
4.3
"stopped
transmission CTS"
4.4
" stopped
transmission XOFF"
4.5
Errors during date transmission to sprinter or
computer
"incorrect date"
5.1
Entered date incorrect
"Exceeded time"
6.1
Exceeded time during an operation (e.g. zeroing)
To Next Page
Loading...
