88
APPENDIX A
Programming of bar code scanner (description for users Power Scan
QS6000+).
Programming means reading appropriate codes in appropriate order from book
attached to scanner „Programming Guide”.
Way of operating is described in „Programming Guide” attached to scanner.
Speed of transmission RS 232 in scanner is default set on 9600 b/sec. If
change is necessary , program the scanner in appropriate way.
1. Programming the type of reading by scanner barcode
Symbology Selection
SET
Enable EAN-13 (type of code at choice)
END
2. Setting the prefix for WLT balance
Label Transmit Configuration, Settings Global Prefix(es)
SET
Set Prefix
0
1
END
3. Setting the suffix for WLT balance
Label Transmit Configuration, Setting Global Suffix(es)
SET
Set Suffix
C
R
END
4. Setting label ID location
SET
LABEL I.D. = NONE
END
Notice:
RADWAG standard is – no symbology sign in the frame (pure code)
(Symbology specification – LABEL I.D. = NONE)
To Next Page
Loading...
