R&S EB200 - Format Subsystem; Trace

EB200 Manual FORMat subsystem
4052.2000.02 4.33 E-7
4.5.7 FORMat subsystem
FORMat
. :BORDer NORMal|SWAPped
Specifies whether binary data is first to be transferred with low or high byte.
Note:
This command only has an effect upon the trace data. For UDP data there is a separate setting
possibility, described in Annex F (Datagram Communication).
Parameters:
NORMal MSB -> ... -> LSB
SWAPped LSB ->... -> MSB
*RST state:
NORMal
Example:
FORMat:BORDer SWAPped
. :BORDer?
Query of output order for binary data
Parameters:
none
Result:
NORM, SWAP
Result:
FORMat:BORDer? -> SWAP
. [:DATA] ASCii|PACKed
Specifies the output format of the following queries:
SENSe:DATA?
TRACe:DATA?
Parameters:
ASCii output with ASCII format
PACKed output with internal binary data format
*RST state:
ASCii
Example:
FORMat PACKed