EB200 Manual Operation
4052.2000.02 3.38 E-7
3.18.4.2 MEASURE (configuration of measuring time parameters)
(See also Annex E (Measuring Functions))
Softkeys
The softkeys indicate in each case the active state inversely.
CONTIN continuous measurement of all values
PERIODIC periodic measurement of all values with measuring time
Configuration of the MEASURE parameter
MEASURE TIME: Measuring time: DEFAULT / 0.5 msec to 900 sec
The TIME MEASURE applies globally to all measuring functions and can also be set in some other
CONFIG menus. In part the name is shortened from lack of space with MTIME.
Note:
A measuring time other than the DEFAULT can only be adjusted with IF sections that are fitted with the
DDC2 (see also "SYSTEM menu" on page 40).
IF-PAN MODE: Level evaluation in the
spectrum of the IF panorama: MIN, MAX, AVG, CLRWRITE
To Next Page
Loading...
