EB200 Manual Operation
4052.2000.02 3.36 E-7
3.18.3.7 Spectrum display with BW ZOOM
For a more accurate analysis of single signals the BW ZOOM can be set on. In this mode there is a firm
rule that one pixel on the y-axis equals one channel and thus the frequency range of half the IF
bandwidth. When the BW ZOOM is set on, the frequency mark is set to the display center and from
there a new frequency span is built corresponding with above rule. If the IF bandwidth will be changed
now the frequency span will be carried along correspondingly. The old span and center frequency and
IF bandwidth are stored when the BW ZOOM is set on and when it is set off they are restored.
3.18.4 RX-CONF (receiver configuration)
This menu is obtained by pressing the RX-CONF softkey in the MAIN menu.
Softkeys
ANT Branch into the menu for antenna number parameters
ATT Branch into the menu for attenuator parameters
MEASURE Branch into the menu for measuring time parameters
AF Branch into the menu for Audio Frequency parameters
SYSTEM Branch into the menu for software versions and software releases
TEST Branch into the menu for built-in test
To Next Page
Loading...
