R&S EB200 - Memory Subsystem

EB200 Manual MEMory subsystem
4052.2000.02 4.42 E-7
4.5.11 MEMory subsystem
This subsystem contains all the functions necessary to operate the EB200 memory locations. The
memory locations are addressed with the text (see "Parameters" on page 9) MEM0 to MEM999 (memory
location 0 to memory location 999). Some commands allow the receiver (data set of receiver settings)
to be addressed by Character Data RX, the currently set memory location by CURRENT and the
next free memory location by NEXT .
The number of the currently active memory location can also be queried by the MSCAN:CHAnel?
command.
MEMory
. :CLEar <name> [,<count>|MAXimum]
Clearing the contents of a memory location. A certain number of memory locations to be cleared may
also be specified.
Parameters
<name> MEM0 to MEM999 | CURRENT
<count> number of memory locations to be cleared from memory location
<name>; as a default value <count> = 1 is accepted
MAXimum clearing all memory locations from <name> to the last memory
location
Example:
MEMory:CLEar MEM123
. :COPY <src_name>, <dest_name>
Copy the memory contents from src to dest
Parameters:
<src_name>|RX MEM0 to MEM999 |RX | CURRENT
<dest_name>|RX MEM0 to MEM999 |RX | CURRENT|NEXT
Example:
MEMory:COPY MEM123, MEM10