R&S EB200 - Route Subsystem

EB200 Manual ROUTe subsystem
4052.2000.02 4.54 E-7
4.5.13 ROUTe subsystem
ROUTe
. :CLOSe <channel_list>
Selection of an antenna. Prior to this the old antenna must be switched off with ROUTe:OPEN:ALL
(see ROUTe:SELect).
Error message:
If more than one antenna is to be selected an execution error -221,"Settings conflict" is
generated.
Parameters:
<channel_list> allowed to contain only one number (0 to 99)
*RST state:
@0
Example:
ROUTe:CLOSe (@23)
. :CLOSe? <channel_list>
Query of whether the respective antenna is selected
Parameters:
<channel_list> contains one value for each antenna number to be queried
Result:
0 for each non-selected antenna number
1 for each selected antenna number
Example:
ROUTe:CLOSe? (@2, 10:12, 23) -> 0,0,0,0,1
. . :STATe? [MINimum|MAXimum]
Query of selected antenna
Parameters:
none query of currently selected antenna
MINimum|MAXimum query of smallest/largest antenna number
Result:
Antenna number as <Definite Length Block>
Example:
ROUTe:CLOSe:STATe? -> #15(@23)