R&S EB200 - Status:operation Register

EB200 Manual Remote control
4052.2000.02 4.134 E-7
4.7.3.4 STATus:OPERation register
In the CONDition section, this register contains information about the type of actions currently being
executed by the device. In the EVENt section, it also contains information about the type of actions
having been executed since the last reading. It can be read using the commands
"STATus:OPERation:CONDition?" or
"STATus:OPERation[:EVENt]?".
Table 4-4 Bit allocation of STATus:OPERation register
Bit No. Meaning
3
SWEeping
This bit is set when the sum bit of STATus:OPERation:SWEeping bits is set
4
MEASuring
This bit is set for the duration of a measurement
8
TESTing
This bit is set when a self-test is triggered