EB200 Manual Operation
4052.2000.02 3.50 E-7
3.18.5.3 TONE (signal tone; pitch depends on the signal level)
The menu is obtained by pressing the TONE softkey in the DISPLAY menu.
This menu shows the expanded level bar display (see "Level display" on page 8).
Starting from this value, the level scale is expanded into the range -15 to +15 dB and the level
magnitude is represented by the pitch of a tone (0 dB corresponds to about 400 Hz).
When the MORE softkey is pressed, the following selection modes are available.
TONE - CONFIG
This menu is obtained by pressing the CONFIG softkey in the TONE menu.
MEASURE TIME: Measuring time: DEFAULT / 0.5 msec to 900 sec
TONE: Tone without/with audio frequency ONLY / WITH AF
Note:
A measuring time other than the DEFAULT can only be adjusted with IF sections that are fitted with the
DDC2 (see also "SYSTEM menu" on page 40).
To Next Page
Loading...
