EB200 Manual Operation
4052.2000.02 3.4 E-7
MAIN menu
M-SCAN (scan with stored values)
RUN (starts scan)
STOP(stops scan)
SUPP (suppresses memory location)
CONFIG (selects configuration menu)
RUN (starts scan)
ACTIVATE (activates memory location)
SUPP (suppresses memory location)
DELETE (clears current memory location or all memory locations)
RX <-> MEM (swaps the receiver parameters with contents of memory location)
F-SCAN (frequency scan)
RUN (starts scan)
STOP (stops scan)
SUPP (suppresses frequency range)
CONFIG (go to configuration menu)
RUN (starts scan from current frequency)
SUPP (suppressed frequency ranges)
SORT (sorts suppressed frequency ranges)
DELETE (deletes current line from the table)
DEL ALL (deletes the whole table)
D-SCAN (RF spectrum display, option)
NORM DIFF (differential or normal spectrum)
RUN STOP (sweep mode: listening mode)
BW ZOOM (change-over to bandwidth-zoom mode)
RND 60 (Y-scaling for 20, 40, 60, 80 dB of the spectrum display)
CONFIG (change into the configuration menu)
NORM DIFF (normal or differential display of the spectrum)
MAX (max. hold in the spectrum display)
CLRWRITE (clear write in the spectrum display)
RNG 60 (Y-scaling for 20, 40, 60, 80 dB)
|<- ->| ^ (start, stop, marker frequency) or <-> >|< ^ (span- center-, marker frequency)
RX-CONF (receiver configuration)
ANT (antenna number and code)
MEASURE (measuring time and cycle)
CONTIN (continuous measurement)
PERIODIC (periodic measurement)
AF (AF parameters SPEAKER, TONE, BALANCE)
SYSTEM (displays system data)
PROTECT (password protection)
EDIT PW (enter password)
DEL PW (delete password)
SW OPT (display and installation of software options)
INSTALL (installation of software options)
RESET (reset to the default values)
TEST (self-test)
LONGTEST (starts overall test)
To Next Page
Loading...
