EB200 Manual Operation
4052.2000.02 3.6 E-7
3.3 Display
Fig. 3-2: Display
Working area
The working area can be expanded for certain, display-intensive menus or for panorama displays, but
the direct-function fields, the VAR potentiometer functions and the display area for the spinwheel
functions will be partially or completely obscured.
Direct functions
The currently selected state of each key function (except softkeys) is displayed in an LCD window next
to or below the key in question.
VAR pot functions
At the top of the display, there are three fields for the MGC, SQU and TONE functions. Their values can
be adjusted with the digital VAR potentiometer.
Spinwheel functions
In the upper right hand corner of the display, there is a field in which the current function of the
spinwheel (FRQ, MEM, LOCK) is displayed. If in a submenu for configuring a parameter, the spinwheel
function is set to this parameter, the short designation or the symbol for this parameter (eg T_DWELL,
T_NOSIG, CYCLES etc) is displayed in this field.
Softkey area
The six fields that provide the labelling for the softkeys below are provided for every menu status.
The softkey bar may be temporarily obscured by status and error messages.
To Next Page
Loading...
