R&S EB200 - Annex G (Coverage Measurement)

EB200 Manual Operation
4052.2000.02 3.42 E-7
SW OPT software options
This menu is obtained by pressing the SW OPT softkey in the SYSTEM menu.
Display parameter:
Status display, activated SW options
DIGI SCAN OPTION: Quick sweep function with spectrum display and remote-controlled
output of all measured values
COVERAGE MEASUREMENT: Fast externally or internally triggered level measurement on a
frequency or on a frequency list This option can be used only via
remote control. See also Annex G (Coverage Measurement).
FIELD STRENGTH: With this option it is possible to carry out field strength
measurements. Additionally to the level indication in dBµV the field
strength is indicated in dBµV/m. For the calculation of the antenna
correction factors the K-factors of the Rohde & Schwarz antennae
HE200 and HE200HF as well as a generic dipole are permanently
stored. Self-defined K-factor data can be loaded into the EB200 via
remote control. See also Annex H (Field Strength Measurement).
Softkey
INSTALL Branches to the SW_OPT menu
Activating a SW option by entering an 8-digit code number
Note:
When ordering a software option at a later stage the serial number of the EB200 is to be indicated.