R&S EB200 - Output Subsystem

EB200 Manual OUTPut subsystem
4052.2000.02 4.46 E-7
4.5.12 OUTPut subsystem
OUTPut
. :AUXMode FREQuency|ANTCtrl
The AUX mode switch determines whether the frequency in BCD or the antenna number in BCD and
the CTRL byte should be output at the rear-panel AUX connector X8.
The FREQuency setting is to be used together with DF Unit EBD190.
Parameter:
FREQuency Frequency output at AUX
4-digits in BCD (1, 10, 100, 1000 MHz)
ANTCtrl Output of antenna number in 2-digit BCD (ANTA1...ANTA80)
Output of binary CTRL bytes (CTRL1 ..... CTRL8)
*RST status:
ANTCtrl
Example:
OUTPut:AUXMode FREQuency
. :AUXMode?
Query of the AUX mode switch setting
Parameter:
None
Result:
FREQ frequency output
ANTC output of antenna number and CTRL byte
Example:
OUTPut:AUXMode?
→ FREQ