EB200 Manual Operation
4052.2000.02 3.30 E-7
3.18.2.1 F-SCAN - CONFIG
This menu is obtained by pressing the CONFIG softkey in the F-SCAN menu.
,
Softkeys
RUN- Scan starts from the current frequency or the stop frequency with decreasing
frequency. There is a menu change after F-SCAN
RUN+ Scan starts from the current frequency or the start frequency with increasing frequency.
There is a menu change after F-SCAN
SUPP Goes to the F-SCAN CONFIG SUPP configuration menu
Configuration of the scan range parameters
Select F-scan range
|<- Start frequency: 10 kHz to 3 GHz
->| Stop frequency: 10 kHz to 3 GHz
<-> Step frequency: 1 Hz to 10 MHz
Configuration of the scan-run parameters
T_DWELL Dwell time: 0.0 to 10.0 sec /infinity
T_NOSIG Continues under signal control after pause: OFF/ 0.0 to 10.0 sec
CYCLES Number of scan cycles: 1 to 1000 / infinity
Note:
The scan may automatically go from the RUN state to the STOP state when the CYCLE-COUNT is
reached.
To Next Page
Loading...
