EB200 Manual SENSe subsystem DEModulation
4052.2000.02 4.61 E-7
. :DEModulation AM|FM| PULSe|A1|CW|LSB|USB|IQ|A0
Switchover of type of demodulation
Note:
For SSB demodulation (CW, LSB and USB,) the frequency stepwidth is set to 1 Hz..
Error message:
If the set bandwidth exceeds 9 kHz at CW, LSB and USB, an error -221,"Settings conflict" will
be generated if one of the SSB operating modes is to be switched on.
Parameters:
FM switch on FM demodulator
AM switch on AM demodulator
PULSe switch on pulse demodulator
CW or A1 switch on SSB demodulator 1 kHz beat
USB switch on SSB demodulator upper sideband
LSB switch on SSB demodulator lower sideband
IQ or A0 switch on IQ demodulator
*RST state:
FM
Example:
DEModulation FM
. :DEModulation?
Query of demodulation type
Parameters:
none
Result:
FM, AM, PULSe, CW, USB, LSB, IQ
Example:
DEModulation? -> FM
To Next Page
Loading...
