EB200 Manual TRIGger subsystem
4052.2000.02 4.120 E-7
. :SOURce EXTernal|INTernal|TIMer
Selection of the trigger source in modes FASTlevcw and LIST
Parameters:
EXTernal Trigger is performed via an impulse to rear-panel connector X8,
pin 12. The trigger slope can be selected with command
TRIGger:SLOPe.
INTernal Trigger is performed internally as quickly as possible. As soon as
a measurement is completed the next one begins.
TIMer Trigger is initiated by a periodic timer. The timer period can be
set with command
TIMer.
*RST state:
INTernal
Example:
TRIGger:SOURce EXTernal
. :SOURce?
Query of currently set trigger source
Parameters:
none
Result:
EXT, INT, TIM
Example:
TRIGger:SOURce? -> EXT
To Next Page
Loading...
