Hardware overview
R&S
®
TS7124M
14User Manual 1525.5394.02 ─ 05
Figure 3-2: Rear view of the drawer door
5 = Profile grooves for sealing the door
6 = RF absorber foam
7 = Upper position inside the drawer door for mounting the DUT holder tray
8 = Two openings in the absorber foam for accessing the feedthroughs (only in RF shielded box version
1525.8564.12)
9 = Lower position inside the drawer door for mounting the DUT holder tray
Several profile grooves (5) in the door and an optional absorber plate (6) help to seal
the chamber against leakage of electromagnetic radiation.
On the inside of the drawer door of the RF shielded box, it is possible to fix various
optional DUT holder trays:
●
standard or custom-made
●
with or without raster for DUT positioning
●
directly mounted to the door or fixed with the help of an adapter
Such a tray is intended to hold the DUT during insertion into the chamber and during
the test.
Front tour
To Next Page
