Accessories
R&S
®
TS7124M
32User Manual 1525.5394.02 ─ 05
●
Vivaldi antenna R&S TS-F24-V2
●
Cross-polarized Vivaldi antenna R&S TS-F24-V3
●
Also, you can mount each Vivaldi antenna on the 45° adapter for lateral antenna tilt
R&S TS-F2X-VH4, which is compatible also with the half antenna ring.
Figure 6-3: Half antenna ring with three rails (or antenna ring bars, or cross struts)
1 = Rail 1
2 = Rail 2
3 = Rail 3
4 = Stiffening rib (one on the left, one on the right-hand side)
5 = Half antenna ring plate (one in the front, one rear)
6 = Label "FRONT", indicating the front side of the half antenna ring
The rails (or bars, or cross struts) in the half antenna ring are numbered 1 - 2 - 3 from
left to right as in Figure 6-3, seen from the front of the chamber.
You can mount various antennas to the rails by special antenna fixtures, as described
in Chapter 7.10, "Configuring Vivaldi antennas", on page 119:
Antenna holders
To Next Page
Loading...
