Operating Instructions D50+ | P50+ | SHERAprint 50
Rapid Shape GmbH │ DOCR000438
WA RNING!
Risk of injury due to harmful materials!
The chemical materials required for the production and
post-processing of 3D print matter can release harmful
vapours and cause dizziness and irritation of the
respiratory tract. Direct skin contact may cause skin
irritation.
– It is necessary to provide sufficient fresh air.
– Wear appropriate protective clothing and carry
out the work with ventilation if necessary.
– Comply with the dosing instructions from the
respective manufacturer.
– Please take note of the safety data sheets for the
respective materials.
1.5.5 Danger due to Hot Surfaces
CA UTION !
Risk of injury due to hot surfaces!
The hot air fans in the machine can heat up during
operation and cause hot surfaces on the fan housing.
– The hot air fans are not allowed to be touched
when hot.
1.5.6 Danger of Material Damage
NOTE!
Material damage due to overheating!
Too high ambient temperatures and a disabled air
outlet may lead to an overheating of the overall system.
– The air outlet must never be covered.
– Maintain the specified ambient temperature.
(→ Chapter 12.1)
– Never install the machine in a closed cabinet.
– Keep a minimum distance of 50 cm behind the
machine so that the heat generated can be
dissipated without hindrance.
To Next Page
Loading...
Need help?
General
