Operating Instructions D50+ | P50+ | SHERAprint 50
Rapid Shape GmbH │ DOCR000438
11 Disassembly & Disposal
11.1 Disassemble the Machine
DAN GER !
Danger to life due to electric current!
Coming into contact with live components runs the risk
of death due to electrocution.
– Before starting disassembly work, the power
supply must be finally disconnected.
WA RNING!
Risk of injury due to improper disassembly!
Stored residual energy, sharp, pointed components and
tools can cause injuries.
– Disassembly work may only be carried out by
qualified personnel.
– Sufficient space must be ensured before the
disassembly work begins.
– Wear appropriate protective clothing.
– Handle edged and pointed components
carefully.
– If necessary, secure components so that they
cannot fall down during work.
– In case of doubt, please contact the Customer
Service.
CA UTION !
Risk of injury due to sharp objects!
The knife on the separation unit has a sharp edge that
can cause slight hand injuries through direct contact.
– The edge should never be touched directly.
Only hold the knife by the knurled nuts and with
the blade away from your body.
To disassemble the machine, please proceed as follows:
1. Switching off the machine. → Chapter 8.1
2. Unplug the power supply.
3. If inserted, remove the following components from the machine:
– Knife and collection basket
– Build platform
– Material reservoir
4. If present, remove any soiling.
5. Now dismantle the machine properly into its individual parts.
Then dispose of the individual parts. → Chapter 11.2
To Next Page
Loading...
Need help?
General
