EasyManuals Logo

Rapid Shape D50+ User Manual

Rapid Shape D50+
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #61 background imageLoading...
Page #61 background image
Operating Instructions D50+ | P50+ | SHERAprint 50
61 96
Rapid Shape GmbH DOCR000438
7.10 Removing Jobs
7.10.1 Removing Jobs with the Automatic Separation Function
NOTE!
Wearing protective gloves protects the skin from contact
with skin damaging materials. During work steps in
which you work with printing materials or cleaning
agents, we always recommend wearing protective
gloves.
Proceed as follows to remove automatically separated print jobs:
1. Prerequisite: No separation process is in course.
2. Wear protective gloves on your hands.
3. Open the upper hood.
4. Remove the collection basket and place it on a paper towel.
Caution! Watch out for material dripping from the collection
basket. Hold the basket at a slight angle towards the back to
prevent material from leaking out. Also place a paper towel
directly underneath the basket opening.
5. Remove the print job from the basket.
Check the number of parts.
6. Place the basket back in the holder and reset the collection
basket status back to empty.
7. Close the upper hood.
8. Begin with post-processing the print job immediately.
Chapter 7.11
When removing the print job from the collection basket,
check the total number of printed parts and their
surfaces for rough damage.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rapid Shape D50+ and is the answer not in the manual?

Rapid Shape D50+ Specifications

General IconGeneral
BrandRapid Shape
ModelD50+
Category3D Printers
LanguageEnglish

Related product manuals