Operating Instructions D50+ | P50+ | SHERAprint 50
Rapid Shape GmbH │ DOCR000438
NOTE!
Wearing protective gloves protects the skin from contact
with skin damaging materials. During work steps in
which you work with printing materials or cleaning
agents, we always recommend wearing protective
gloves.
Proceed as follows to post-cure your print jobs:
1. Wear protective gloves on your hands.
2. Open the post-curing unit x_cure.
3. Place the cleaned components in the exposure chamber.
The components must not be stacked on top of each other and
should not cast shadows over each other. The maximum
component height is not allowed to be exceeded.
4. Close the lid.
5. Select the operating mode and start the curing process.
For further information, please refer to the separate
operating instructions for the x_cure. → x_cure
To post-cure your print jobs with another post-curing
device, please refer to the respective printing material
instructions for the information you require.
After the cleaning and post-curing process, check the component for
the desired result.
If you notice that the print result deviates from the
desired result, please repeat the workflow, or contact
Customer Service.
To Next Page
Loading...
Need help?
General
