Operating Instructions D50+ | P50+ | SHERAprint 50
Rapid Shape GmbH │ DOCR000438
10.1.6 Cleaning the Collection Basket
NOTE!
Wearing protective gloves protects the skin from contact
with skin damaging materials. During work steps in
which you work with printing materials or cleaning
agents, we always recommend wearing protective
gloves.
After the separation process, the separated print jobs fall into the
collection basket for removal. During printing, liquid material that sticks
to the components collects after some time in the collection basket. The
collection basket needs to be cleaned or alternatively changed each
time the material is changed to avoid mixing different materials.
Safety gloves, isopropanol, paper towels, brush/small brush
For cleaning the collection basket, please proceed as follows:
1. Wear protective gloves on your hands.
2. Open the upper hood.
3. Remove the collection basket and place it on a paper towel.
Caution! Watch out for material dripping from the collection
basket. Hold the basket at a slight angle towards the back to
prevent material from leaking out. Also place a paper towel
directly underneath the basket opening.
4. Clean the collection basket with a brush or small brush and
isopropanol. Then wipe the basket dry with paper towels.
5. Place the basket back in the holder.
6. Close the upper hood.
To Next Page
Loading...
Need help?
General
