Rapid Shape D50+ User Manual

Operating Instructions D50+ | P50+ | SHERAprint 50
9 │ 96
Rapid Shape GmbH │ DOCR000438
1.2 Intended Use
The 3D Printing System is designed for printing three dimensional
objects with wavelength and DLP suitable printing materials (flash point
> 80°C) in additive production (DLP processing). The digital workflow
is to be observed (→ Chapter 1.2.1).
The printing system is designed for temperature-controlled interiors
(→ Chapter 12). Proper use requires compliance with all information in
this manual.
Any use going beyond the intended use or otherwise is deemed to be
improper. The operator is exclusively liable for any resulting damage.
Use contrary to the intended use includes, but is not limited to the
following actions:
– Operation within potentially explosive areas
– Operation with explosion-hazardous printing materials
– Outdoor operation
– Operation in tropical climates
– Operation in wet, damp rooms
– Operation without sufficient instruction
– Operation without material reservoir
– Operation without build platform
– Operation without mandatory safety equipment
– Operation with non-approved spare parts
– Operation with defective or modified safety devices
– Operation with printing materials not suited for wavelength and
DLP process
– Removing or modifying attached safety markings
– Improper conversions, modifications, repairs, and maintenance
1.2.1 Digital Workflow
1
Creation of
3D Data
2
Processing
the 3D Data
3
Preparation
of 3D Data
for Printing
System
4
Printing of
the 3D Part
5
Post-
Processing
6
Usage of the
3D Part
The 3D Printing System described in these operating instructions is part
of the digital workflow and is used in steps 3 and 4.

Rapid Shape D50+ Specifications

General

Brand	Rapid Shape
Model	D50+
Category	3D Printers
Language	English