Operating Instructions D50+ | P50+ | SHERAprint 50
Rapid Shape GmbH │ DOCR000438
7.11 Post-Processing Jobs
7.11.1 Cleaning Jobs
NOTE!
Wearing protective gloves protects the skin from contact
with skin damaging materials. During work steps in
which you work with printing materials or cleaning
agents, we always recommend wearing protective
gloves.
Proceed as follows to clean your print jobs:
1. Wear protective gloves on your hands.
2. Open the drawer on the x_wash cleaning unit.
3. Place the individual components in the inner container.
The components must never touch the rotors and cover each
other. The maximum filling level is not allowed to be exceeded.
4. Close the drawer.
5. Select the operating mode and start the cleaning process.
For further information, please refer to the separate
operating instructions for the x_wash. → x_wash
To clean your print jobs with another cleaning device,
please refer to the respective printing material
instructions for the information you require.
To Next Page
Loading...
Need help?
General
