For cleaning the build platform, please proceed as follows:
1. Clean the platform and the platform splash guard with a brush
or small brush and isopropanol.
2. Wipe both components dry with paper towels afterwards.
3. Use a scalpel to remove any hardened material residues.
4. Check that the holes in the platform are free of residues.
5. Reinsert the splash guard into the platform and then into the
machine. → Chapter 7.6.2
6. Then insert the drip guard and the knife back into the machine.
→ Chapter 7.6.3
7. Now insert the knife protection device back into the machine
and push it back as far as it will go to close the knife protection
device.
8. Close the upper hood.
To Next Page
Loading...
Need help?
General
