Rauch AXIS EMC ISOBUS - Page 2

Dear customer,
By purchasing the AXIS EMC ISOBUS machine control unit for the AXIS EMC fertilizer spreader,
you have shown confidence in our product. Thank you very much! We want to justify this
confidence. You have purchased a powerful and reliable machine control unit.
However, in case unexpected problems arise, our customer service department is always there for
you.
Please read this operator's manual as well as the operator’s manual for the machine
carefully before using the machine, and follow the advice given.
This manual may also describe equipment that is not included in your machine control unit.
Note the serial number of the machine control unit and of the machine
The AXIS EMC ISOBUS machine control unit has been calibrated at the factory
for the mineral fertilizer spreader with which it was supplied. It cannot be
connected to another machine without recalibration.
Please enter the serial number of the machine control unit and of the machine
here. When connecting the machine control unit to the machine, these numbers
must be checked.
Serial number of electronic machine control unit:
Machine serial number:
Machine year of manufacture:
Technical improvements
We continuously strive to improve our products. For this reason, we reserve the right to make any
improvements and changes to our machine that we consider necessary without notice. We do not
accept any obligation to make such improvements or changes on machines that have already been
sold.
We will be pleased to answer any other questions that you might have.
Yours sincerely
RAUCH Landmaschinenfabrik GmbH