Manual mode:
In the manual mode, the operating lights can be switched on and off.
u
Access the menu Main menu > SpreadLight.
u
Put a check mark in the menu item Activate [2].
The operating lights are activated and remain on until you remove the check mark or leave the menu.
4.11 Hopper cover
WARNING!
Danger of crushing and shearing due to externally-actuated components
The hopper cover will move without warning and can cause personal injury.
▶
Ensure that nobody is present in the hazard zone.
The AXIS EMC machine is equipped with an electrically operated hopper cover. During the refilling
process at the end of the field, you can open and close the hopper cover using the control unit and an
electrical drive.
The menu is only used for operating the actuators which open or close the hopper cover. The
AXIS EMC ISOBUS machine control unit does not detect the exact position of the hopper cover.
• Monitor the movement of the hopper cover.
4. Operation
AXIS EMC ISOBUS 5902180-h-gb-
65
To Next Page
Loading...
