Rauch AXIS EMC ISOBUS - Operation; Switching on the machine control unit

4 Operation
CAUTION!
Risk of injury due to discharged fertilizer
In the case of a fault, it is possible that the metering slide unexpectedly opens during road
transport to the spreading location. There is a risk of slipping and personal injury due to ejected
fertilizer.
▶
Before leaving for the spreading location, always switch off the electronic machine control
unit.
The settings of each menu are very important for optimal mass flow control (EMC function).
Please be particularly aware of the specifics of the EMC function for the following menu items:
• In the Fertilisersettings > Spreading disc menu, see page 40
• In the menu Fertilisersettings > Disc speed or the Fertilisersettings > Normal disc speed
menu, see page 41
• In the menu Machinesettings > AUTO/MAN mode, see chapter 4.5.1
4.1 Switching on the machine control unit
Requirements:
• The machine control unit is correctly connected to the machine and the tractor.
○ For an example, see Chapter 3.2.2 Connecting the machine control unit.
• The minimum voltage of 11 V is guaranteed.
u
Start the machine control unit.
After a few seconds, the start-up screen of the machine control unit is displayed.
Subsequently, the machine control unit displays the activation menu for a few seconds.
u
Press the enter key.
The operating screen then appears.
4. Operation
28
5902180-h-gb- AXIS EMC ISOBUS