The limited border spreading function is also possible in automatic mode with GPS Control. The
border spreading side must be manually operated at all times.
• See 5.11 GPS control.
5.6 Spreading with the automatic operating mode (AUTO km/
h + AUTO kg)
The AUTO km/h + AUTO kg operating mode allows for continuous regulation of the application rate
during the spreading operation. The mass flow control is corrected at regular intervals on the basis of
this information. This way, fertilizer metering can be optimized.
The AUTO km/h + AUTO kg operating mode is preselected as the standard factory default.
Requirements for spreading:
• The AUTO km/h + AUTO kg operating mode is active (See 4.5.1 AUTO/MAN mode).
• The fertilizer settings are defined:
○ Application rate (kg/ha)
○ Working width (m)
○ Spreading disc
○ Normal disc speed (RPM)
u
Fill the hopper with fertilizer.
WARNING!
Risk of injury caused by ejected fertilizer
Ejected fertilizer may cause severe injury.
▶
Make sure nobody is present in the spreading zone of the machine before switching on
the spreading discs.
u
AXIS-H only: Press Spreading disc start.
u
Press the enter key to clear the alarm message. See 6.1 Meaning of the alarm messages.
The Idle measurement screen is displayed.
The Idle measurement starts automatically. See 5.7 Idle measurement.
u
Press Start/Stop
The spreading starts.
5. Spreading operation
AXIS EMC ISOBUS 5902180-h-gb-
83
To Next Page
Loading...
