u
Access the menu Machine settings > AUTO/MAN mode.
u
Select the MAN km/h menu item.
The display shows the input window Forward speed.
u
Enter the value for the forward speed during spreading.
u
Press OK.
u
Configure the fertilizer settings:
w
Application rate (kg/ha)
w
Working width (m)
u
Fill the hopper with fertilizer.
In order to achieve an optimum spreading result in the MAN km/h operating mode, a calibration is
to be carried out before starting the spreading.
u
Carry out a calibration to determine the flow factor or obtain the flow factor from the fertilizer chart
and enter the flow factor manually.
u
AXIS-H only: Press Spreading disc start.
u
Press Start/Stop
The spreading starts.
Always observe the set forward speed during spreading.
5.10 Spreading in the MAN scale operating mode
The MAN scale operating mode, you can manually adjust the metering slider opening during the
spreading operation.
The manual mode is only applied:
• If there is no speed signal (radar or wheel sensor not available or defective)
• when spreading slug pellets or fine seeds
The MAN scale operating mode is appropriate for slug pellets and fine seeds since the automatic
mass flow control cannot be activated due to the low weight reduction.
5. Spreading operation
88
5902180-h-gb- AXIS EMC ISOBUS
To Next Page
Loading...
