Rauch AXIS EMC ISOBUS - Spreading operation; Requesting the remaining quantity during spreading; Refilling

5 Spreading operation
The machine control unit helps you to enter the machine settings before starting work. During
spreading, functions of the machine control unit are also active in the background. This allows you to
monitor the quality of the fertilizer spreading.
5.1 Requesting the remaining quantity during spreading
For weighing spreaders only
During spreading, the remaining quantity is continuously recalculated and displayed.
During spreading, i.e. with the dosing sliders being open, you can switch to the Trip counter menu
and read off the remaining quantity currently in the hopper.
During spreading, the remaining quantity is continuously recalculated and displayed.
If the values are to be permanently monitored during spreading, freely assignable display fields in
the operating screen can also be assigned the kg left, ha left or m left values, refer to Chapter
2.2.2 Display fields.
Working with the weighed remaining quantity, refilling the hopper:
u
Tare the scales.
See chapter 4.9.3 Zero scales.
u
Select the fertilizer type used.
See chapter 4.4.12 Fertilizer charts.
u
Fill the hopper.
u
Weigh the fertilizer quantity in the hopper.
u
Start your work.
When the hopper is empty, refill it:
u
Fill the hopper.
u
Weigh the fertilizer quantity in the hopper.
u
Start your work.
5.2 Refilling
For weighing spreaders only
Requirement:
ü
The kg level sensor function in the Machine settings menu is active.
5. Spreading operation
AXIS EMC ISOBUS 5902180-h-gb-
73