3 Attachment and installation
3.1 Tractor requirements
Before installing the machine control unit, ensure that your tractor meets the following requirements:
• A minimum voltage of 11 V must always be guaranteed, even if multiple loads are connected
simultaneously (e.g. air conditioning system, lights)
• Oil supply: max. 210 bar, single or double-acting valve (depending on equipment)
• AXIS-M: The PTO speed must have the following values and must be complied with (basic
requirement for a correct working width).
○ AXIS-M 20.2, AXIS-M 30.2/40.2: minimum 540 rpm
○ AXIS-M 50.2: minimum 750 rpm
On tractors without load-switchable transmission, the forward speed must be selected by
using the correct gear ratio in such a way that it corresponds to a PTO speed of 540 rpm
(AXIS-M 20.2, AXIS M 30.2) or 750 rpm (AXIS M 50.2).
• AXIS-H 30 EMC: Hydraulics performance of 45 l/min, constant current or load sensing system
• AXIS-H 50 EMC: Hydraulics performance of 65 l/min, constant current or load sensing system
• Free return min. NW 18 mm
• 9-pin socket (ISO 11783) located at the rear of the tractor, for connecting the machine control unit
to ISOBUS
• 9-pin terminal plug (ISO 11783) for connecting an ISOBUS terminal to the ISOBUS
If the tractor is not equipped with a 9-pin socket at the rear, a tractor assembly set including a
9-pin socket for the tractor (ISO 11783) and a forward speed sensor may be purchased
additionally as special equipment.
3.2 Connections, sockets
3.2.1 Power supply
The power supply of the machine control unit is implemented via the 9-pin socket at the rear of the
tractor.
3.2.2 Connecting the machine control unit
Depending on the equipment, there are different methods for connecting the machine control unit to
the mineral fertilizer spreader. Further information can be obtained from the operator’s manual of your
machine control unit.
3. Attachment and installation
AXIS EMC ISOBUS 5902180-h-gb-
23
To Next Page
Loading...
