Rauch AXIS EMC ISOBUS - Spreading operation with one section and in border spreading mode

5.5.4 Spreading operation with one section and in border spreading mode
VariSpread V8
During spreading operation, the sections can be changed gradually and limited border spreading can
be deactivated. The figure below shows the operating screen with boundary spreading activated and a
section activated.
Fig. 43: Operating screen with one section on the left, border spreading side on the right
[1] Spreading side on the right in the boundary
spreading mode
[2] Increase the spreading disc speed on the
limited border spreading side
[3] Boundary spreading mode is activated
[4] Right spreading side is activated
[5] Reduce or increase left section
[6] Reduce the spreading disc speed on the
limited border spreading side
[7] Left section adjustable in 4 steps
[8] The current boundary spreading mode is
Limited bd.
• The application rate on the left is set to the full working width.
• The Right limited border spreading function key has been pressed, limited border spreading is
active, and the application rate is reduced by 20%.
• Press the Reduce left spreading width function key in order to reduce the section.
• If you press the C/100 % function key, the full working width will be reapplied immediately.
• By pressing the Right limited border spreading function key, the boundary spreading function is
deactivated.
5. Spreading operation
82
5902180-h-gb- AXIS EMC ISOBUS