During operation, the Quantity +/ Quantity - function keys can be used to adjust the application
rate by the +/- Quantity factor at any time. The pre-configuration can be reset with the C 100 %
key.
Specifying the application rate reduction:
u
Access the menu Machine settings > +/- appl. rate (%).
u
Enter the percentage by which the application rate is to be adjusted.
u
Press OK.
4.6 Fast emptying
In order to quickly clean the machine after spreading or to quickly empty any residual material, you
can select the Fast emptying menu.
For this purpose, before storing the machine, we recommend completely opening the metering
sliders with the fast emptying function and switching off the control unit in this state. This prevents the
accumulation of humidity in the hopper.
Before starting the fast emptying process, care must be taken to ensure that all requirements
have been met. Observe the operator’s manual for the mineral fertilizer spreader (discharging
residual material).
4. Operation
AXIS EMC ISOBUS 5902180-h-gb-
53
To Next Page
Loading...
