Rauch AXIS EMC ISOBUS - Page 54

Carrying out the fast emptying process:
u
Access the menu Main menu > Fast emptying.
CAUTION!
Risk of injury due to automatic adjustment of the drop point
With AXIS EMC, the Approach drop pointYes = Start alarm message appears. When you
press the Start/Stop function key, the drop point automatically moves to position 0. After the
calibration, the drop point automatically moves to the preset value again. This may cause
injury and property damages.
▶
Before pressing the Start/Stop key, ensure that nobody is present in the hazard zone of
the machine.
Fig. 21: Menu Fast emptying
[1] Icon for fast emptying (here: left side
selected, not started)
[2] Fast emptying of the right section (selected)
[3] Fast emptying of the left section (not
selected)
u
Press the function key to select the section for which the fast emptying function is to be carried
out.
The selected section is displayed as an icon (Fig. 21 position [3]).
u
Press Start/Stop.
The fast emptying process starts.
u
Press Start/Stop when the hopper is empty.
Fast emptying is complete.
u
ESC to return to the Main menu.
4. Operation
54
5902180-h-gb- AXIS EMC ISOBUS